Title page for ETD etd-07062005-070755


Type of Document Master's Thesis
Author Jeong, Gi Young
Author's Email Address gjeong1@lsu.edu
URN etd-07062005-070755
Title Fracture Behavior of Wood Plastic Composite (WPC)
Degree Master of Science (M.S.)
Department Renewable Natural Resources
Advisory Committee
Advisor Name Title
Qinglin Wu Committee Chair
Kun Lian Committee Member
W. Ramsay Smith Committee Member
Keywords
  • crack opening angle
  • polar coordinates
  • fem
Date of Defense 2005-06-24
Availability unrestricted
Abstract
In this study, the effect of notch length on impact strength and fracture toughness was examined to exploit the use of wood plastic composite (WPC) as structural materials. Impact and fracture toughness test methods and estimation procedures were carried out. To evaluate the impact strength of WPC, five different notch sizes with two different fiber orientations on the load head were prepared. In terms of fracture mechanics, notch length was converted to stress concentration factor and the relationship between stress concentration factor and impact strength was determined. Fracture surface of impact specimens was investigated to evaluate the fracture mechanism of WPC by scanning electron microscopy (SEM). For the determination of fracture toughness of WPC, a short bar specimen with a rectangular cross section and a different notch size was used. To obtain the stress intensity factor (KI) for the mode I case, a finite element method (FEM) was carried out. The simulation of the stress intensity factor was performed on four successively refined meshes via quarter point elements around the crack tip. By means of an asymptotic analysis, the verification of the simulation was also presented. The experimental results showed that impact strength of WPC was highly dependant upon the fiber orientation and stress concentration factor. However, fracture toughness was independent of the change of the length of the notch. Fracture toughness of WPC was estimated to be 1.79 MPa√m using a four point bending test. The results of the simulation showed that stress intensity factor of WPC was estimated to be 584.9 (kPa√m). The results of normal stress at the crack tip from a common sequence of four successively refined meshes were diverged while the results of the stress intensity factors converged. The strength of singularity for normal stress (σx) was 4.92 which is quite close to that of true singularity (0.5) for the sharp crack tip when Θ=180. Crack opening angle (COA) of the four point bending specimen was also estimated to be 50 on the basis of strength of singularity determined from finite element method.
Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  Jeong_thesis.pdf 4.26 Mb 00:19:44 00:10:09 00:08:53 00:04:26 00:00:22

Browse All Available ETDs by ( Author | Department )

If you have questions or technical problems, please Contact LSU-ETD Support.