Title page for ETD etd-0702103-151700


Type of Document Master's Thesis
Author Liang, Ya
Author's Email Address yliang1@lsu.edu
URN etd-0702103-151700
Title Carbon Dioxide Capture from Flue Gas Using Regenerable Sodium-Based Sorbents
Degree Master of Science in Chemical Engineering (M.S.Ch.E.)
Department Chemical Engineering
Advisory Committee
Advisor Name Title
Douglas Patrick Harrison Committee Chair
Elizabeth J. Podlaha Committee Member
James J. Spivey Committee Member
Keywords
  • GC
  • capture
  • carbon dioxide
  • TGA
Date of Defense 2003-06-09
Availability unrestricted
Abstract
The overall objective of this project is to develop a simple and inexpensive process to separate carbon dioxide (CO2) as an essentially pure stream from a fossil fuel combustion gases using a regenerable sodium-based sorbent. This objective of this phase of the project is to evaluate CO2 capture using sodium-based sorbents in single-cycle and multicycle tests as a function of calcination and carbonation conditions. The sorbent precursors investigated were sodium bicarbonates supplied by Church and Dwight, Inc., and natural trona supplied by Solvay. All precursors were first calcined to sodium carbonate and then converted to sodium bicarbonate (NaHCO3) or Wegscheider’s salt (Na2CO3?NaHCO3) through reaction with carbon dioxide and water vapor. Both sodium bicarbonate and Wegscheider’s salt are regenerated to sodium carbonate when heated, producing a nearly pure CO2 stream after condensation of water vapor.

An electrobalance reactor (thermogravimetric analyzer) and a fixed-bed reactor system were used to study the reaction rate and achievable sorbent capacity as a function of carbonation temperature, carbonation gas composition, and calcination temperature and atmosphere. Sorbent reproducibility and durability were studied in multi-cycle tests.

Electrobalance tests show that sodium bicarbonate (SBC) samples had better performance than Trona samples. Lower carbonation temperature (60oC) and higher CO2/H2O concentrations resulted in faster reaction rate and larger sorbent capacity. More severe calcination conditions had a more significant negative effect on Trona than SBC sorbents. In addition, a small amount SO2 (<0.1%) resulted in a cumulative decrease in CO2 removal capacity with increasing carbonation cycle number.

Results from 1.5-cycle fixed-bed reactor tests indicate that better CO2 removal efficiency for SBC-3 was achieved at a lower carbonation temperature of 60oC, where average prebreakthrough concentrations corresponded to approximately 75% CO2 removal. There was no obvious deterioration with cycle number. Instead, improved performance between cycle 1 and the remaining cycles was clear for SBC Grades 1 and 3 under the reaction conditions investigated. Prebreakthrough CO2 removal (at the third carbonation sample) increased from 63% in cycle 1 to about 90% for the remaining cycles at 60oC carbonation.

Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  Liang_thesis.pdf 2.94 Mb 00:13:36 00:06:59 00:06:07 00:03:03 00:00:15

Browse All Available ETDs by ( Author | Department )

If you have more questions or technical problems, please Contact LSU-ETD Support.