Title page for ETD etd-06062011-031330


Type of Document Dissertation
Author Qin, Wenting
Author's Email Address wqin1@lsu.edu
URN etd-06062011-031330
Title Analytical Design Method for Cold Production of Heavy Oil with Bottom Water Using Bilateral Sink Wells
Degree Doctor of Philosophy (Ph.D.)
Department Petroleum Engineering
Advisory Committee
Advisor Name Title
Wojtanowicz,Andrew K. Committee Co-Chair
White,Christopher D. Committee Co-Chair
Hughes, Richard Committee Member
Sears,Stephen O. Committee Member
Wascom,Michael W. Dean's Representative
Keywords
  • water cresting control
  • improve oil recovery
  • bottom water drive
  • cold production
  • heavy oil
Date of Defense 2011-05-18
Availability unrestricted
Abstract
Few heavy oil reservoirs with strong bottom water drives have been developed successfully because of severe water coning. Water coning tends to cause low ultimate recovery, low well productivity, and high water production. Although thermal and gravity-assisted methods might improve recovery in oil reservoirs, such methods are widely perceived as either economically unfavorable or technologically infeasible. This study proposes a new, cold production technique, called Bilateral Water Sink (BWS), to meet those challenges.

The BWS method suppresses water cresting by producing oil and water simultaneously from separate, horizontal wells completed in the oil and water zones; the oil and water completions are parallel, with the oil well directly above the water well. In conventional horizontal well production, water cresting causes water to bypass oil, making the water drive mechanism ineffective. BWS controls water invasion by altering the pressure distribution in the near-well area. With cresting suppressed, the oil completion remains water-free, allowing water to displace oil from the edges of the well drainage area to the oil completion, increasing ultimate recovery. Unlike existing heavy oil recovery methods, BWS exploits the natural reservoir energy in the bottom water drive. This makes BWS economically, technically, and environmentally appealing – especially for offshore applications, where cold production is currently the only option and oil-water separation is a problem.

In this study, BWS oil recovery is investigated analytically and numerically. A new mathematical model identifies controlling variables and project design parameters, and describes the relationships among them. The design model is used to select rates of water and oil in BWS wells for best performance. The analytical model is verified by a comparison to numerical simulations. These two approaches together provide the quantitative account of the BWS’s effect on avoiding water cresting and improving oil recovery. The results show that BWS can increase oil recovery from 10 percent to over 40 percent in a conventional case, while avoiding the problem of oil-contaminated water production. As a result, the mathematical model of BWS well behavior is shown to be a practical reservoir management tool to guide development of heavy oil reservoirs with bottom water drives.

Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  Qin_diss.pdf 1.22 Mb 00:05:40 00:02:54 00:02:33 00:01:16 00:00:06

Browse All Available ETDs by ( Author | Department )

If you have questions or technical problems, please Contact LSU-ETD Support.