Title page for ETD etd-04222012-072633


Type of Document Master's Thesis
Author Fry, Mark B.
Author's Email Address MarkBFryME@gmail.com
URN etd-04222012-072633
Title Low-Order Modeling of Micro-Flier Impact with Thin Stationary Energetic Targets
Degree Master of Science (M.S.)
Department Mechanical Engineering
Advisory Committee
Advisor Name Title
Gonthier, Keith Committee Chair
Guo, Shengmin Committee Member
Li, Guoqiang Committee Member
Keywords
  • laser driven flier
  • impact
  • flier
  • high speed impact
Date of Defense 2011-12-15
Availability unrestricted
Abstract
The impact of high-speed (500-1500 m/s), laser driven micro-fliers with thin energetic targets (10-100 &# 956;m) is being examined to characterize impact-induced heating and combustion of these materials. Aluminum fliers are propelled by a laser into a thin metallic target plate having a layer of energetic material deposited on its backside. Mass spectrometry is performed in vacuo on the energetic side to interrogate the shock-induced chemistry of the energetic material. It is important to ignite and possibly detonate the energetic material without perforation of the target plate avoiding contamination of the vacuum chamber.

To guide development of these experiments, a low-order (zero-dimensional) model is formulated to estimate ballistic performance for large dimensional parameter spaces in a computationally inexpensive manner. The imaging of post-impact target coupons gives insight into deformation and failure modes of the target plate. The model accounts for both the early-time system response with 1-D shock relations and the late-time response with quasi-static strength of flat plates. The model is validated against impact data for larger scale flier-target configurations, and gives predictions for micro-scale configurations. The post-impact target plates show that the system behavior is stochastic in nature. Thus, a method for propagating input uncertainty is presented to estimate the uncertainty in model output variables, and a sensitivity study is performed to highlight dependence of the system response on input parameters. Model output is most sensitive to the ratio of flier width to diameter. Predictions are performed for energetic materials including HMX (C4H8N8O8), TNT (C7H5N3O6), and PETN (C5H8N4O12) over the initial flier velocity - flier thickness parametric plane for given target thicknesses to produce ballistic initiation maps to identify configurations for which initiation of energetic material may occur without perforation of the target plate. Because of the high critical shock initiation energy of HMX (150 J/cm2) and TNT (77 J/cm2), it is difficult to identify micro configurations that result in initiation. However, such configurations were found for PETN which has a lower critical shock energy (5.03 J/cm2). The area of the region for initiation increases with increasing target thickness for these configurations.

Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  ABSTRACT.pdf 21.62 Kb 00:00:06 00:00:03 00:00:02 00:00:01 < 00:00:01
  Fry_Thesis.pdf 25.62 Mb 01:58:36 01:00:59 00:53:22 00:26:41 00:02:16

Browse All Available ETDs by ( Author | Department )

If you have questions or technical problems, please Contact LSU-ETD Support.